fbpx

Linux KVM: Disable virbr0 NAT Interface

The virtual network (virbr0) used for Network address translation (NAT) which allows guests to access to network services. However, NAT slows down things and only recommended for desktop installations. To disable Network address translation (NAT) forwarding type the following commands:

 

Display Current Setup

Type the following command:
# ifconfig
Sample outputs:

virbr0 Link encap:Ethernet HWaddr 00:00:00:00:00:00
inet addr:192.168.122.1 Bcast:192.168.122.255 Mask:255.255.255.0
inet6 addr: fe80::200:ff:fe00:0/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:39 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:7921 (7.7 KiB)

Or use the following command:
# virsh net-list
Sample outputs:
Name State Autostart
—————————————–
default active yes

To disable virbr0, enter:
# virsh net-destroy default
# virsh net-undefine default
# service libvirtd restart
# ifconfig 

Leave a Reply

Your email address will not be published. Required fields are marked *